Current Location : HomePage > News

One-way car starter must drive under what conditions

One-way car starter must drive under what conditions

* : * : admin * : 2014-11-13 * : 75
0
     In the car started before, the natural first start the engine. The car started, the car is completely stationary state from gradual acceleration. If the drivetrain (which links the entire car) rigidly contact with the engine, the transmission of a hanging file, the car will suddenly look forward, but it does not start. This is because when the car from standstill to pediment, have a great inertia force, causing the engine drag torque greatly. In this role inertial moment of resistance, a sharp decline in the blink of time the engine speed to the minimum steady speed (usually 300-500RPM) below, namely the engine stalled and can not work, of course, cars can not be started.
     After engine start, before the car started, the driver depresses the way starter pedal first, the starter-way separation, the engine and drivetrain disengaged, then the transmission is in gear, and then gradually release the starter one-way pedal, so that way starter gradually engaged. In the bonding process, the engine torque is gradually increased hindered, it should also gradually depressing the accelerator pedal, i.e., gradually increasing the amount of fuel supplied to the engine so that the engine speed is always maintained at a minimum stable speed, without flameout. Also, because the way the starter engages the tightness increases, the engine torque transmitted to the drive wheels via the drivetrain will gradually increase, when sufficient to overcome the initial resistance to traction, the car begins to move from static and gradually accelerates 2, ensure smooth drivetrain shift work
     Starter way can be divided into: Friction way starter as a transmission or the use of liquid media (ie hydraulic coupling), or the use of magnetic transmission (ie one-way solenoid starter
     Way starter drive must conditions:
     (1) engaging splines modulus same pressure angle gear teeth and the armature assembly keyway on the inner mandrel way starter.
     (2) one-way starter gear teeth meshing with the outer ring of the diesel engine flywheel pressure modulus same angle.
     (3) When replacing the starter one-way, because no replacement starter armature assembly mandrel and the diesel engine flywheel ring gear, so check the tooth inside and outside the pitch circle diameter must be replaced with the same one-way starter.
     Due to the current automotive electrical manufacturer specifications produced by way starter model is not unified, the replacement starter one-way, to meet the above conditions, only one manufacturer producing the same type of one-way only interchangeable.
     Therefore, under normal circumstances, the production of different manufacturers are not interchangeable way starter.
News Sort